Alcoholic and Acetic Fermentation – Esterification

Integrated ScienceChemical ReactionsAges 14–15Virtual lab

Use with my class

A fermentation vessel holds a glucose solution: switch on the yeast and CO₂ bubbles rise as the ethanol level climbs day by day. The simulation calculates the ethanol formed from C₆H₁₂O₆ → 2C₂H₅OH + 2CO₂ and converts it to alcohol content as ethanol volume divided by solution volume times 100. Move on to the acetic fermentation stage to oxidize ethanol into acetic acid and watch the vinegar concentration, or to the esterification stage to heat the acid with the alcohol using concentrated H₂SO₄ to form a fragrant ester. Drag the temperature to see the yeast work best around 30 °C and die above 40 °C. A second tab compares this with industry: yeast fermentation of sugar at about 30–35 °C against the catalytic hydration of ethene with steam over H₃PO₄ at about 300 °C and 6–7 MPa. Students change the temperatures and the pressure, run 72 hours of production and compare the rate, the ethanol formed per pass, purity, batch against continuous operation, atom economy and the sustainability of each raw material.

Lesson: Ethanol, Acetic Acid and Esterification; industrial ethanol: fermentation against hydration of ethene

What it shows

Yeast ferments glucose anaerobically, C₆H₁₂O₆ → 2C₂H₅OH + 2CO₂, so 180 g of glucose gives at most 92 g of ethanol; activity peaks near 30 °C, stops above 40 °C or at about 14° alcohol. Acetic acid bacteria then oxidise ethanol to acetic acid, and esterification reaches about 67% yield. Industry also makes ethanol by hydrating ethene with steam over a phosphoric acid catalyst at about 300 °C and 6–7 MPa: an exothermic equilibrium, so the conditions are a compromise, with only about 5% converted per pass and the rest recycled. Hydration is fast, continuous and has a 100% atom economy but uses crude oil; fermentation is slow and batchwise but uses renewable crops.

How to use

In the Fermentation lab, set the Temperature slider to about 15 °C, 30 °C and 45 °C, pressing New Batch each time, then press Next Stage for acetic fermentation and esterification. In Fermentation vs hydration, each run covers 72 hours: move Hydration temperature and Pressure to find the conditions that convert the most ethene per pass, compare the rates of the two plants in the table, and work out the atom economy of fermentation in Check yourself.

Parameters you can change

  • Stage Alcoholic fermentation: glucose → ethanol + CO₂, Acetic fermentation: ethanol + O₂ → acetic acid, Esterification: acid + alcohol ⇌ ester + water
  • Initial glucose concentration 50–300 g/L
  • Incubation temperature 10–45 °C
  • Solution volume 0.5–5 L
  • Simulation speed 0.2–2 days/s
  • View Fermentation lab, Fermentation vs hydration
  • Hydration temperature 200–400 °C
  • Hydration pressure 1–10 MPa

Questions to explore

  1. Why is almost no ethanol produced when the mixture is kept at 45 °C?
  2. What mass of ethanol forms when 180 g of glucose is fermented completely?
  3. Why does the esterification yield level off at about 67% even after long heating?
  4. Why is ethene hydrated at about 300 °C and 6–7 MPa rather than at a lower temperature, which would give a higher equilibrium yield?