Loudspeakers and Moving-Coil Microphones: Motor and Generator Effects
PhysicsElectric & Magnetic FieldsAges 17–18Virtual lab
How do you mainly use this simulation?
Use it with your class: students open it from a link or a QR code, with no account needed.
Loudspeaker: an alternating current in a coil sitting in a radial magnetic field feels a force F = BIL that drives the cone and makes a sound; the frequency of the current sets the pitch and its amplitude sets the loudness. Microphone: sound moves a diaphragm and its coil through the field, the flux linkage of the coil changes and an alternating p.d. is induced, shown on an oscilloscope. The loudspeaker uses the datasheet of a real woofer and the microphone the sensitivity of a real dynamic microphone. Each reading records the force or the induced p.d. against frequency and amplitude.
Lesson: Loudspeakers (motor effect, F = BIL on the coil) and moving-coil microphones (generator effect, induced p.d. = BLv); pitch and loudness; the oscilloscope
What it shows
In a loudspeaker a coil fixed to the cone sits in the narrow gap of a magnet, where the field points radially. Every part of the wire is at right angles to the field, so the force F = BIL acts along the axis. An alternating current makes the force reverse again and again, so the cone vibrates at the frequency of the current and sends out sound: a higher frequency gives a higher pitch and a larger current a louder sound. A moving-coil microphone works the other way round: sound moves the coil through the field, the flux linkage changes and an alternating p.d. is induced.
How to use
On the Loudspeaker tab set the Current frequency f and the Current amplitude I₀, watch the coil, the cone and the sound, and read F₀, the cone amplitude and the sound level. On the Microphone tab choose the Sound source, its frequency and pressure amplitude, set Time per division and Voltage per division, and read the trace. Press Record reading each time.
Parameters you can change
- Device Loudspeaker, Microphone
- Current frequency f 20–2500 Hz
- Current amplitude I₀ 0–1 A
- Sound source Tone you set, Sound X
- Sound frequency f 50–15000 Hz
- Sound pressure amplitude p₀ 0–3 Pa
- Time per division 0.05–10 ms/div
- Voltage per division 0.2–5 mV/div
Questions to explore
- Why does a radial magnetic field make the force on the loudspeaker coil act along the axis?
- How does the induced p.d. of the microphone change when the sound has twice the pressure amplitude?
- Which effect does a loudspeaker use, and which does a microphone use?