Water and macromolecules – polarity and hydrogen bonding
BiologyCell BiologyAges 15–16
How do you mainly use this simulation?
Use it with your class: students open it from a link or a QR code, with no account needed.
The water mode draws polar H₂O molecules with an oxygen end carrying a partial negative charge and two hydrogen ends carrying a partial positive charge, shows hydrogen bonds as dashed lines and continuously counts the average number of bonds per molecule; cooling below 0 °C locks molecules into an ice lattice with greater spacing (so ice floats), heating to 100 °C breaks all hydrogen bonds as the water evaporates, and adding salt or sugar shows water molecules surrounding and dissolving them, while oil stays undissolved. The macromolecule mode shows how monomers of carbohydrates, lipids, proteins and nucleic acids link into chains. A Properties of water screen measures the density of water at each temperature (it is densest just above freezing, so lakes freeze from the top), compares the temperature rise of water, ethanol and sand for the same energy, explains why water boils far above H₂S and why it dissolves ionic and polar substances, with a card on common water pollutants.
Lesson: Chemical elements, water and biological macromolecules
What it shows
Water molecules are polar, so neighbours attract one another through hydrogen bonds. These bonds explain water's surface tension, its high specific heat capacity, its high boiling point compared with H₂S and its power to dissolve ions and polar substances, while oils stay separate. Ice holds four hydrogen bonds per molecule in an open lattice, so it floats, and liquid water is densest just above its freezing point, which is why lakes freeze from the top. A properties screen lets you measure these effects and lists common water pollutants. A second mode shows the four classes of biological macromolecules and how their monomers join by condensation.
How to use
In water mode, drag the Water temperature from below 0 °C to above 100 °C and watch the hydrogen bonds per molecule, then change the Substance added to water. Press View macromolecules to step through each Macromolecule to view. Press Properties of water for five tabs: measure density at each temperature, cool a lake, heat water, ethanol and sand with the same energy, compare boiling points and see what water dissolves.
Parameters you can change
- Content Water and hydrogen bonding, Four macromolecule classes, Properties of water
- Water temperature -20–110 °C
- Substance added to water Nothing added, Table salt NaCl (polar), Glucose sugar (polar), Cooking oil (non-polar)
- Macromolecule to view Carbohydrate – glucose monomer, Lipid – glycerol and fatty acids, Protein – amino acid monomer, Nucleic acid – nucleotide monomer
- Number of water molecules shown 12–60 molecules
- Properties screen Density, Freezing lake, Heat capacity, Boiling point, Solvent and pollutants
- Density sample Liquid water, Ice
- Sample temperature -10–30 °C
- Air temperature over the lake -15–25 °C
- Mass of each sample 100–250 g
- Energy for each sample 2–6 kJ
- Show the trend without hydrogen bonds
- Substance in the solvent view Sodium chloride, NaCl, Glucose, Ethanol, Calcium carbonate, CaCO₃, Iodine, I₂, Cooking oil
Questions to explore
- How does the average number of hydrogen bonds per molecule change as ice is heated to vapour?
- Why do salt and glucose dissolve in water while cooking oil stays as a separate layer?
- Which of the four macromolecule classes is not built from a single repeating monomer?