Solution concentration – add solid, drip, evaporate

Integrated ScienceMatter & MaterialsAges 13–14

Use with my class

Drag a shaker to sprinkle in solid solute or a dropper to add concentrated solution to a beaker of water, hold the tap to add water or drain some away, and drag the evaporation slider to concentrate the solution gradually. Drop the concentration probe into the solution to read the concentration directly in mol/L; once the solubility limit is exceeded, the excess settles at the bottom of the beaker as a solid and no more will dissolve. Eight familiar solutes (sugar, table salt, copper(II) sulfate, potassium permanganate, potassium dichromate, potassium chromate, cobalt(II) chloride, nickel(II) chloride) each have their own color and solubility limit. Based on the "Concentration" simulation by PhET Interactive Simulations, University of Colorado Boulder (CC BY 4.0); rewritten. Two more screens: a solubility-curve practical (dissolve a weighed salt such as potassium nitrate in 10 cm³ of water, heat, cool slowly and record the temperature at which crystals appear, then compare your curve with data for six salts, including supersaturated sodium ethanoate, with a balance showing that mass is conserved) and gas solubility (Henry's law for O₂, N₂ and CO₂ at different temperatures and pressures, and an opened fizzy-drink bottle).

Lesson: Solutions and concentration

What it shows

Molar concentration is the amount of solute in each litre of solution: C = n/V. Adding water dilutes a solution and evaporation concentrates it; every solute has a solubility limit, beyond which the excess settles as a solid. The Solubility curve screen is the classic practical: dissolve a known mass of salt in 10 cm³ of water, cool it and note the temperature at which crystals first appear; that point gives the solubility in g per 100 g of water. Most salts dissolve better when hot, whereas gases dissolve less in warm water and more under higher pressure (Henry's law).

How to use

On the Concentration tab, choose the Solute:, pick Add Solid or Drip Solution, drag the shaker or dropper over the beaker and hold; use Hold: Add Water, Hold: Drain and Evaporate:. On the Solubility curve tab, choose the Salt and Mass of salt, raise the Water-bath temperature until it dissolves, press Cool slowly, then Crystals appear – record when crystals form. On the Gases tab, change the Water temperature and Partial pressure of the gas, and press Open the bottle.

Parameters you can change

  • Solute Sugar (sucrose), Table salt (NaCl), Copper(II) sulfate (CuSO₄), Potassium permanganate (KMnO₄), Potassium dichromate (K₂Cr₂O₇), Potassium chromate (K₂CrO₄), Cobalt(II) chloride (CoCl₂), Nickel(II) chloride (NiCl₂)
  • How to add solute Add solid, Drip stock solution
  • Show formula C = n/V
  • Screen Concentration (mol/L), Solubility curve practical, Gas solubility (Henry's law)
  • Salt (solubility curve) Potassium nitrate, Sodium chloride, Potassium chloride, Ammonium chloride, Copper(II) sulfate, Sodium ethanoate
  • Mass of salt 0.5–25 g
  • Volume of water 5–20 cm³
  • Water-bath temperature 0–100 °C
  • Gas Oxygen, Nitrogen, Carbon dioxide
  • Water temperature (gases) 0–50 °C
  • Partial pressure of the gas 0–500 kPa