Radio wave modulation – AM and FM

PhysicsOscillations & WavesAges 16–17

Use with my class

An audio-frequency signal cannot travel far on its own, so it must be carried by a high-frequency carrier wave. Adjust the signal frequency, carrier frequency, and modulation depth to compare amplitude modulation (AM), where the carrier's amplitude varies, with frequency modulation (FM), where its frequency varies, and see why FM resists amplitude noise better. A Receiver screen tunes an LC circuit to one of three AM stations and recovers its audio with a diode and an RC envelope detector, then a series capacitor removes the DC level; a poor RC leaves ripple or distorts the sound.

Lesson: Transmitting information by radio waves

What it shows

Audio signals of hundreds to thousands of hertz are too low in frequency for a practical antenna to radiate, so radio carries them on a high-frequency carrier. In AM the carrier's amplitude follows the audio, so the envelope has the shape of the signal; in FM the amplitude stays constant and the instantaneous frequency follows the signal, which is why FM shrugs off amplitude noise. A receiver first selects one station with an LC circuit tuned to f₀ = 1/(2π√(LC)); a diode and an RC load then follow the envelope, which works only when 1/f_c ≪ RC ≪ 1/f_s, and a series capacitor removes the steady level.

How to use

Start in AM and vary Depth m while watching the dashed envelope, change Signal and Carrier, then switch Type to FM and tick Amplitude noise to compare the recovered signals. Press Receiver to open the AM receiver: change the Tuning capacitor C (and the Coil L) until f₀ matches a station, choose the Detector resistor R and the Detector capacitor C, compare ripple and distortion, and press Record reading for each setting.

Parameters you can change

  • Modulation type Amplitude modulation (AM), Frequency modulation (FM)
  • Audio-frequency signal 200–2000 Hz
  • Carrier-to-signal frequency ratio 4–20 times
  • Modulation depth m 0.1–1
  • Add amplitude noise in transmission
  • Screen Modulation (AM and FM), AM receiver
  • Receiver coil L 100–500 µH
  • Tuning capacitor C 30–400 pF
  • Detector resistor R 1–100 kΩ
  • Detector capacitor C 0.1–47 nF
  • Series capacitor before the earphone

Questions to explore

  1. In an AM wave, which feature of the wave carries the sound information, and which feature carries it in an FM wave?
  2. What happens to the shape of the AM wave as the modulation depth m approaches 1?
  3. Why does amplitude noise distort the recovered AM signal but hardly affect the FM signal?
  4. Why does too short an RC leave ripple in an AM receiver, while too long an RC distorts the sound?