Motional EMF, Eddy Currents and Magnetic Braking
PhysicsElectric & Magnetic FieldsAges 17–18Virtual lab
How do you mainly use this simulation?
Use it with your class: students open it from a link or a QR code, with no account needed.
Four screens on electromagnetic induction in moving conductors. Sliding rod: a weight pulls a rod along rails in a magnetic field; the EMF ε = Blv, the current, the backward force BIl (Lenz's law) and the speed are recorded over time as the rod approaches its terminal speed, and the work done by the weight is compared with the heat in the resistor and the kinetic energy. Falling magnet: identical magnets fall through copper, aluminium and plastic tubes. Eddy-current brake: a metal disc slows down between the poles of an electromagnet. Motor: the back EMF rises with speed while the current falls.
Lesson: Motional EMF, Lenz's law, eddy currents, magnetic braking and the back EMF of a motor
What it shows
A conductor moving through a magnetic field has an EMF across it, ε = Blv. In a closed circuit this EMF drives a current, and the field pushes on the current with a force that, by Lenz's law, always opposes the motion. A rod pulled by a weight therefore speeds up only until this force equals the weight: its terminal speed is mgR/(B²l²), and the work done by the weight turns into heat and kinetic energy. The same idea explains why a magnet falls slowly through a copper tube, how eddy-current brakes slow trains, and why a motor draws less current once it is running.
How to use
In Sliding rod, choose B, l, R and the hanging mass, press Release and follow v, ε, I and F on the graph and in the table, then answer the terminal-speed task. In Falling magnet, press Drop and compare the three fall times for each magnet and wall thickness. In Eddy-current brake, change the field and the disc, then press Spin and brake. In Motor back EMF, press Switch on, change the load torque and press Record reading.
Parameters you can change
- Screen Sliding rod, Falling magnet, Eddy-current brake, Motor back EMF
- Magnetic field B 0.1–1 T
- Distance between the rails l 0.1–0.5 m
- Resistance R 0.1–2 Ω
- Hanging mass m 0–50 g
- Mass of the rod M 20–200 g
- Starting push v₀ 0–3 m/s
- Field direction Into the page, Out of the page
- Magnet Neodymium, Ferrite
- Wall thickness of the tubes 0.5–3 mm
- Disc metal Aluminium, Copper
- Disc Solid, Slotted
- Field between the poles B 0–0.3 T
- Starting speed n₀ 100–600 rpm
- Supply voltage V 0–12 V
- Load torque 0–50 mN·m
Questions to explore
- Why does doubling the resistance R double the terminal speed of the rod?
- Why does the magnet take longer to fall through copper than through aluminium, and why does it fall freely through plastic?
- Why is the current in a motor largest at the moment it is switched on?