Thermal Power Station: Efficiency, Energy Losses and CO₂
PhysicsPhysics & the EnvironmentAges 15–16
How do you mainly use this simulation?
Use it with your class: students open it from a link or a QR code, with no account needed.
Follow the energy from fuel to the grid in a thermal power station: boiler (or gas turbine), turbine, generator, transformer and power lines. Choose a coal, oil, open-cycle gas, combined-cycle gas, combined heat and power (CHP) or nuclear plant and set its efficiency within the published range. A Sankey diagram shows where each megawatt goes – up the stack, into the cooling water, in the generator, used by the plant and lost on the grid – and a chart compares the efficiency and CO₂ per kWh of every plant. An extraction tab shows coal mining, an oil well and a shale gas well with hydraulic fracturing (fracking).
Lesson: Thermal power stations: energy transfers and efficiency, Sankey diagrams, combined cycle and cogeneration (CHP), CO₂ per kWh by fuel, extracting coal, oil and natural gas (fracking)
What it shows
A thermal power station turns the chemical energy of a fuel, or the nuclear energy of uranium, into heat, the heat into the turning of a turbine, and the turning into electricity. Most of the energy is lost on the way, above all as warm cooling water in the condenser, so a coal plant sends out only about 35–45 % of its fuel energy as electricity. A combined-cycle gas plant reuses the hot exhaust of its gas turbine and reaches about 60 %, and a CHP plant that also supplies heat uses about 80 %. CO₂ per kWh is the fuel's CO₂ per kWh of heat divided by the efficiency.
How to use
Choose a Plant type and drag Electrical efficiency (net) within its published range. In the Sankey diagram each arrow that leaves the band is a loss, and its width shows how many megawatts it carries. The chart beside it compares every plant. Press Record this plant to add the energies, the efficiency and the CO₂ per kWh to the table. Open Extracting the fuel to see how coal, oil and natural gas are taken from the ground.
Parameters you can change
- View Power station, Extracting the fuel
- Plant type Coal-fired steam plant, Oil-fired steam plant, Open-cycle gas turbine, Combined-cycle gas turbine (CCGT), Gas-fired combined heat and power (CHP), Nuclear power station
- Electrical efficiency (net) 30–61 %
- Fuel extracted Coal, Oil, Natural gas
Questions to explore
- Why does a coal-fired power station lose far more energy in its cooling water than up its chimney?
- Why does a combined-cycle gas plant emit less than half the CO₂ per kWh of a coal plant?
- How can a combined heat and power plant use about 80 % of its fuel energy?