Operational Amplifier Circuits: Gain, Saturation and Bandwidth

PhysicsElectricity & CircuitsAges 16–17Virtual lab

Use with my class

Build an inverting, non-inverting or summing amplifier or a comparator round an LM741 op-amp. Choose the resistors, the input waveform, its amplitude and frequency and the supply, and watch the input and output on an oscilloscope: the output is the input times −R_f/R_in or 1 + R_f/R_1, it flattens about 1 V inside the supply rails, and at high frequency the gain falls because gain × bandwidth stays near 1 MHz. Each reading records the input, the output and the gain.

Lesson: Operational amplifiers: inverting, non-inverting and summing amplifiers, the comparator, saturation and the gain–bandwidth product

What it shows

An operational amplifier multiplies the difference between its two input voltages by about 200 000. With negative feedback through a resistor, the output settles where the two inputs are almost equal, so the resistors alone set the gain: −R_f/R_in for the inverting amplifier and 1 + R_f/R_1 for the non-inverting one. A summing amplifier adds weighted inputs, and without feedback the op-amp becomes a comparator whose output jumps to a rail. Two real limits appear: the output cannot reach the supply voltage, so large signals clip, and the gain falls at high frequency because gain × bandwidth stays near 1 MHz for an LM741.

How to use

Pick a circuit on the tabs, then set the resistors, Waveform, Amplitude, Frequency and Supply. Read the input and output peaks and the measured gain under the oscilloscope, and press Record reading to add a row to the table. Raise the amplitude until the output flattens, then raise the frequency and watch the gain fall on the gain–frequency graph.

Parameters you can change

  • Circuit Inverting amplifier, Non-inverting amplifier, Summing amplifier, Comparator
  • Input resistor R_in (or R₁) 1–100 kΩ
  • Feedback resistor R_f 1–1000 kΩ
  • Second input resistor R₂ 1–100 kΩ
  • Second input voltage V₂ (summing) -5–5 V
  • Reference voltage V_ref (comparator) -10–10 V
  • Input waveform Sine, Square, Triangle
  • Input amplitude (peak) 0.1–10 V
  • Input frequency 10–1000000 Hz
  • Supply voltage ±V_CC 5–18 V

Questions to explore

  1. Why does the output of an amplifier stop growing when you keep raising the input amplitude?
  2. How does the bandwidth of a non-inverting amplifier change when its gain is made ten times larger?
  3. Why is the inverting input of an inverting amplifier called a virtual earth?