Reversible reactions: heating hydrated copper(II) sulfate
ChemistryEnergetics & ThermodynamicsAges 15–16Virtual lab
How do you mainly use this simulation?
Use it with your class: students open it from a link or a QR code, with no account needed.
A virtual lab on a reversible reaction. Heat blue hydrated copper(II) sulfate, CuSO₄·5H₂O, in a boiling tube until its mass is constant: it turns into white anhydrous CuSO₄ and the water condenses in a cooled tube. Then pour the water back onto the white powder standing in an insulated cup of water and measure the temperature rise. The weighings give the water of crystallisation, q = mcΔT gives the energy given out, and an energy level diagram shows that the forward reaction takes in the same energy that the reverse reaction gives out.
Lesson: Reversible reactions and energy changes: hydrated and anhydrous copper(II) sulfate
What it shows
Some reactions can go both ways. Heating blue hydrated copper(II) sulfate drives off its water of crystallisation and leaves white anhydrous copper(II) sulfate; adding water turns the white powder blue again. If a reaction is endothermic in one direction, it is exothermic in the other, and the same amount of energy is transferred each way. Here the mass lost on heating gives the percentage of water, and the temperature rise of the water in an insulated cup gives the energy released, from q = mcΔT. The model ignores heat losses and the heat capacity of the tube.
How to use
Set the mass of Blue crystals and press Heat for 1 minute; the tube is cooled and weighed after each heating. Repeat until two readings agree. Set the Water in the cup, press Add the water back and read the highest temperature. Use the Weighings table for the percentage of water and the temperature rise for q = mcΔT, then answer the tasks to see the sizes on the energy level diagram.
Parameters you can change
- Mass of blue crystals 2–10 g
- Water in the cup 25–200 g
Questions to explore
- Why must the blue crystals be heated until their mass stops changing?
- Why does the white powder get hot when the collected water is poured back onto it?
- How would using less water in the cup change the temperature rise and its percentage error?