Wastewater treatment by microorganisms – activated sludge tank

BiologyBiotechnologyAges 15–16

Use with my class

Wastewater rich in organic matter (high BOD) flows into a tank, where aerobic bacteria feed on the organic matter using oxygen supplied by an aerator. Adjust the influent BOD, aeration level, sludge (biomass) concentration and retention time to see BOD fall, dissolved oxygen change, and when the effluent meets discharge standards; turn the aeration off to see the tank turn anaerobic, treatment slow down, and odors appear. The Full treatment plant view follows the sewage through primary settling, the activated-sludge stage, tertiary nitrogen and phosphorus removal and UV disinfection: take samples after each stage and compare BOD, suspended solids, nitrogen, phosphorus and faecal coliforms (textbook data, von Sperling and Chernicharo 2005).

Lesson: Microbial technology in environmental pollution treatment

What it shows

Biochemical oxygen demand (BOD) is the oxygen microorganisms need to break down the organic matter in water, so it shows how polluted wastewater is. In an activated sludge tank, aerobic bacteria in sludge flocs oxidise this organic matter to CO₂ and water; the rate depends on the sludge, the remaining BOD and the dissolved oxygen supplied by aeration, and without oxygen the tank turns anaerobic and smells. The full plant view places this tank in a sewage works: primary settling removes solids, the biological stage removes most of the BOD, tertiary treatment removes nitrogen and phosphorus, and disinfection kills pathogens.

How to use

Set Influent BOD, then adjust Aeration, Sludge and Retention time while watching the BOD and dissolved oxygen curves, and compare the effluent with the strict and basic limits. Then press Full treatment plant, choose Raw sewage and Phosphorus removal, pick a Sampling point and press Take sample at each point. Use the table and graph to see which stage removes which pollutant.

Parameters you can change

  • Influent wastewater BOD 50–800 mg/L
  • Aeration level 0–100 %
  • Sludge (biomass) concentration 0.5–5 g/L
  • Hydraulic retention time 1–24 h
  • View Aeration tank, Full treatment plant
  • Raw sewage Dilute, Typical, Strong
  • Phosphorus removal Chemical (iron or aluminium salt), Biological only

Questions to explore

  1. What does a high BOD tell you about a sample of wastewater?
  2. Does a higher sludge concentration shorten the time needed to meet the strict discharge limit?
  3. Why does a tank without aeration begin to smell bad?
  4. Which stage of a sewage works removes most of the suspended solids, and which removes most of the phosphorus?