Muscle contraction – the sliding filament model
BiologyHuman & Animal PhysiologyAges 16–17
How do you mainly use this simulation?
Use it with your class: students open it from a link or a QR code, with no account needed.
Watch a sarcomere contract by the sliding filament model: a nerve impulse reaches the neuromuscular junction, the sarcoplasmic reticulum releases Ca²⁺, Ca²⁺ binds troponin so tropomyosin moves, and myosin heads form cross-bridges with actin, make a power stroke and detach using ATP. Change the Ca²⁺ and ATP supply to see a muscle that cannot contract or goes into rigor, measure the A band, I band and H zone, plot the force–sarcomere-length curve, and compare an antagonistic pair and fast and slow muscle fibres. A Myogram screen records an isolated frog muscle stimulated by single pulses, pairs and trains: twitch, recruitment, summation, incomplete and complete tetanus, initial and recovery heat. An ATP supply screen shows where ATP comes from during an effort and the oxygen debt afterwards.
Lesson: Muscle contraction – the sliding filament theory, antagonistic muscles and fibre types
What it shows
Skeletal muscle shortens because actin filaments slide between myosin filaments in each sarcomere: Ca²⁺ released after a nerve impulse lets myosin heads form cross-bridges, and ATP detaches them, so without ATP the muscle goes into rigor. The filaments keep their length, so the A band stays constant while the I band and H zone shorten. A myograph shows how a whole muscle grades its force: more motor units are recruited by stronger stimuli, and repeated stimuli summate into tetanus. ATP is regenerated first by phosphocreatine, then by anaerobic glycolysis and aerobic respiration, and the oxygen debt is repaid during recovery.
How to use
On Sarcomere, press Send nerve impulse or press Remove ATP and watch the heads. On Length–tension, move Sarcomere length and press Record. On Muscles & fibres, pick a Fibre type and press Run fatigue test. On Myogram, choose a Stimulus, set Stimulus strength, Interval between pulses or Stimulation frequency, and press Stimulate; each run goes into the table. On ATP supply, pick a Fibre type and the Length of the effort, then press Exercise.
Parameters you can change
- Screen Sarcomere and cross-bridge cycle, Force–sarcomere length curve, Antagonistic muscles, fast and slow fibres, Myogram: twitch, summation, tetanus, ATP supply during exercise and oxygen debt
- Ca²⁺ released per impulse 0–100 %
- ATP available 0–100 %
- Nerve impulse frequency 0–50 Hz
- Sarcomere length (force measurement) 1.2–3.8 µm
- Fibre type Slow (type I), Fast (type II)
- Stimulus (myogram) Single pulse (strength), Two pulses, Train (frequency)
- Stimulus strength 0–6 V
- Interval between two pulses 2–200 ms
- Stimulation frequency 1–60 Hz
- Length of the effort 10–120 s
Questions to explore
- Why does the A band keep the same length while the I band and H zone get shorter?
- Why do muscles become stiff and locked after death, when ATP runs out?
- Why does a sarcomere produce the greatest force at about 2.0–2.25 µm?